Cisco Systems computer hardware 2900 SERIES XL Håndbog

PDF Håndbøger
138 Sider Engelsk

Cisco Systems computer hardware 2900 SERIES XL
2-27
Catalyst 2900 Series XL Hardware Installation Guide
78-6461-03
Chapter 2 Installation
Connecting to a 10/100 Port
Follow these steps to connect to 10BASE-T and 100BASE-TX devices:
Step 1 When connecting to workstations, servers, routers, and Cisco IP Phones, connect
a straight-through Category 5 cable to an RJ-45 connector on the front panel
(Figure 2-17). When connecting to switches or repeaters, use a crossover
Category 5 cable. Pinouts for the cables are described in the Cable and Adapter
Specifications sectiononpageB-4.
Figure 2-17 Connecting to a 10/100 Switch Port
Note The switch can connect to a Cisco IP Phone through a straight-through,
twisted-pair cable. The rear panel of the Cisco IP Phone might have more than
one RJ-45 jack. Use the LAN-to-phone jack to connect the phone to the
switch. Refer to the documentation that came with your Cisco IP Phone for
information about connecting devices to it.
Step 2 Connect one end of the cable to the RJ-45 connector of the switch 10/100 port.
Step 3 Connect the other end of the cable to an RJ-45 connector of the other device.
The switch port LED comes on when both the switch and the connected device
have established link.
1X 2X 3X
4X 5X 6X
7X
1X 2X 3X
4X 5X 6X
7X
M
O
D
E
47291
Indholdsfortegnelse
Udfold alle
Relaterede Håndbøger til Cisco Systems computer hardware 2900 SERIES XL